Nissan Titan Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
245 Posts
Discussion Starter · #1 ·
Hey guys, I've been looking around for a hitch that will fit in behind my roll pan but to no avail. There is a place in orange county that'll custom make one for me but it's pretty expensive. Long story short, I saw a sick setup on a Titan near my house with an off road tube bumper and the hitch all as one piece. Does anyone have any photo's that might be like this or know of anyone that has done some work that's similar and what the cost was? It would be greatly appreciated.
 

·
Registered
Joined
·
218 Posts

·
Registered
Joined
·
5,748 Posts
Are you actually planning on towing with the bumper? Or is the hitch going to be for a recovery point?
 

·
Registered
Joined
·
5,748 Posts
Most of the off road tube bumpers are not for towing. They are strictly extraction points.
 

·
Registered
Joined
·
245 Posts
Discussion Starter · #6 ·
This one looked like two separate pieces the tube bumper and then a hitch potruding through possibly welded between the frame rails
 

·
Registered
Joined
·
5,748 Posts
jason27 said:
This one looked like two separate pieces the tube bumper and then a hitch potruding through possibly welded between the frame rails
Hmmmmmmm, sounds interesting. That's something I would like to see as well. I really want to get rid of my rear bumper too.
 

·
Registered
Joined
·
1,132 Posts

·
Registered
Joined
·
6,061 Posts

·
Banned
Joined
·
324 Posts
with tims bumper you could easily tow with the hitch. the stock hitch does require modification to fit behind the plate like that, and if i remember correctly tim wont touch the hitch due to liability issues so you have to take the hitch somewhere else which isnt that big of a deal it just needs to be cut and rotated upwards.
 
1 - 11 of 11 Posts
Top