Nissan Titan Forum banner

Sheet Metal Intake

2315 Views 6 Replies 6 Participants Last post by  prelude1911
Here It Is The Sheet Metal Intake .Hogans Manifolds Will Custom Make It .Big Dollar Item,$2600.00


See less See more
1 - 1 of 7 Posts
Those intakes are difficult to make as the insides where the runners connect to the main plenum are usually bedded with epoxy which is carved until all the cylinders are balanced.
Given up the secrets huh?...:upsidedow

I used to crew for a "A" Altered Team running a 500 inch Pro Stock engine, and the plenum top was removable to run two 4 barrel carbs or 4 split carbs....very interesting to see all the inside work done on those manifolds.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.