[KYDeepwater]

Bed Cover

Try www.checkerpro.com. Mine if the Fx model. They make a fiberglass one-piece unit. I have used these on my last three trucks. They can be made with locks, lights, quick-release hinges, etc. I got mine in about 8 days from order time. They are fibergalss with an aluminum rail all around it. Weighs about 60 pounds and can be removed in about three minutes with the quick relaes hinges. Here are a couple of pictures of it on my Titan. With the tailgate lock, it gives me a huge trunk to carry tools, luggage etc. It keeps out almost all rain, the gaps in the tailgate cause a little water to get into the back of the bed. They make each one according to your measurements, in case the bed isn't totally square, so it makes for a good fit.

 

[KYDeepwater]

KYDeepwater,

I'm thinking about being a copy-cat. I like the flat appearence of the Checkerpro cover. Did you remove the factory polyliner from your truck? The checkerpro site seems to show some hook like devices connecting to the side of the truck, is this correct? I notice also that you have left on the bedrail caps, was this just personal preference?

Thanks.

The cover I have has two snap locks inside the bed to lock it without the latch being visible. You can also get the cover with two key locks on top. It has gas shocks to hold it up when you open it. Mine is black as it came from the factory. I have seen them sprayed with Rhino or Line-X, and painted to match the truck.
I didn't get any liner from the dealer because I knew I was going to get this cover, since I carry around tools and a mower a lot. I might get a Rhino or Line-X in a couple of years when I scratch this bed all up moving rocks, wood, etc.