Nissan Titan Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I installed 20pro4x struts on my 2009 4x4 LE. I also installed a 2” RC leveling kit in the front. I have the pro4x rear shocks but haven’t installed them yet.

The front looks and measures higher than the rear. When I measure the top of the wheel to the bottom of the wheel well, there’s a 2” difference. Is this normal? Wouldn’t the front and back measure the same hight if it was “leveled?” Is the pro4x suspension a unique height?

Since installing the leveling kit I have learned that 2” may have been too high, so I don’t really expect the front and back to be the same height. But the difference seems bigger than I would expect.

I plan on putting a 2” spacer in the back to truly level the truck, but I’m still confused as to why I would need 2” in front and back to level the truck.


after leveling:

Wheel Automotive parking light Tire Land vehicle Sky


Before leveling:
Wheel Tire Car Vehicle Sky
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Thanks, that’s very helpful. I’ll probably replace the UCA’s. I haven’t installed the rear pro4x suspension. If the rear shocks are also taller than the gen1 base option, then maybe I wouldn’t need to rear lift blocks. Any insight into that?

If it turns out I need them to level the rear, I’ll reach out to you about your used set. Thanks!
 
1 - 3 of 3 Posts
Top