Nissan Titan Forum banner
1 - 20 of 29 Posts

TrevoRR

· Registered
Joined
·
157 Posts
Discussion starter · #1 ·
I have a 6" Pro Comp lift on my 2wd right now with 33's and I really think that the 33's look too small. So when they finally wear out Im going with 35's. Anyways, I also plan on getting a 3" body lift(i know alot of people dont like body lifts, but its what I plan on getting, so please dont tell me how "bad" body lifts are) and I was wondering if 35's would look too small also.

So anyone with pics thats has about 9" or 10" lift please post them and the specs of your truck/wheel/tire combo.

Thanks, Trevor
 
I can't figure out how to post images from my iPhone so till I can get to my computer see sig.
 
Discussion starter · #3 ·
What is the specs of your lift if you dont mind me asking? And your in Watauga? I lived there 2 years ago and my parents live in Keller. I now live in Denton for school though. Im shocked I havent seen your truck, Im in Watauga/Keller/Southlake all the time.
 
Discussion starter · #5 ·
I have been checking out that thread a lot and Im really liking his truck. After searching a little, I have kinda decided I dont want to go with 37's because I dont want to mess with new gears, which I think is important when you get tires that big. I know 35's are not that different, but a lot of people run 35's without problems.
 
TrevoRR said:
I have been checking out that thread a lot and Im really liking his truck. After searching a little, I have kinda decided I dont want to go with 37's because I dont want to mess with new gears, which I think is important when you get tires that big. I know 35's are not that different, but a lot of people run 35's without problems.
I have to agree with tire choice... I am currently running Nitto's that measured 34" diameter new, and they felt so much better in power and gas mileage since I changed from the original 35"s... but I miss the 35" fill out under the wheel wells so I will be going back to that after I tear these down...
 
Technically standing at 9" with the 8" CST and the Eibach springs. 18x10 Raceline Renegades on 35" Toyo MT's. No rubbing whatsoever.

Image
 
TrevoRR said:
What is the specs of your lift if you dont mind me asking? And your in Watauga? I lived there 2 years ago and my parents live in Keller. I now live in Denton for school though. Im shocked I havent seen your truck, Im in Watauga/Keller/Southlake all the time.
Really. . I work in Ponder and my daughter goes to school in Keller so iam always up and down 35 & 377.

As far as my lift;
Front: 4"Cst spindles, 3" leveling kit, 3" dreaded body lift = 10"
Rear: 4" block, 3" body lift = 7"
I need like 1-1.5" in the front to have the front a little higher then the rear.
then i will either go with 37x14.50 or 38x13.50 iam ordering one each for the test fit.
 
Discussion starter · #10 ·
WhiteTitanSe said:
Really. . I work in Ponder and my daughter goes to school in Keller so iam always up and down 35 & 377.

As far as my lift;
Front: 4"Cst spindles, 3" leveling kit, 3" dreaded body lift = 10"
Rear: 4" block, 3" body lift = 7"
I need like 1-1.5" in the front to have the front a little higher then the rear.
then i will either go with 37x14.50 or 38x13.50 iam ordering one each for the test fit.
Where did you have your body lift installed at? And if you dont mind me asking how much was it for the BL and install? Or did you install it yourself?

I really want to go with a 3" body lift instead of going with coilovers and UCA's for that little extra. I was a little afraid that 35's would look to small with 9" of lift but it seems like it looks just fine.
 
my PA BL was like 350ish shipped then I did the install in my drive way on a Sat.- Sun. Took about 5 hrs each day. Drove it to work Monday, I still need to put on my gapgaurds!
 
Discussion starter · #12 ·
Very nice! Do you know of any shops around this area that does good work? I dont trust myself to install something like a BL on my truck, Im much more of a car person.

Your truck looks badass though! Thanks for your help.
 
Theres a pretty good shop down the street from me on 377 that quoted me 400.00 bucks if I brought them the BL wich is a good deal from a reputable shop. I just figured I could use the 400.00 bucks on something else for my truck.
Thanks for the compliment!
 
Discussion starter · #16 ·
i<3mytitan said:
here's my truck:
Image

CST 8" lift
Radflo 2.5 coilovers set to 2" additional lift
full deaver spring pack
Radflo 2.0 rears
Im really liking your truck! I love how aggressive the tires are, i just couldnt do it for my daily driver, I feel like I would get annoyed of the hum. I really dig the lights in the lower, looks good!
 
^^^
Thanks for the comments. As for the hum, it gets annoying when i stay around 20-30mph, until i either roll the windows down or speed up a bit. the inconvenience is worth the looks my truck gets, though.:rockon
 
trevor, im in ft worth texas and i am in partnership with a 4wd company. look on our website, www.jbccoffroad.com we do all kinds of lifts and bl. you can call addis @ 817-655-0462 and tell him you got his number from RT on titan talk. see what kind of deal we can get you on a bl and install.
 
i<3mytitan said:
the inconvenience is worth the looks my truck gets, though.:rockon
I 2nd that. Nice looking rig man! "idhitit2:
 
rtc1184 said:
trevor, im in ft worth texas and i am in partnership with a 4wd company. look on our website, www.jbccoffroad.com we do all kinds of lifts and bl. you can call addis @ 817-655-0462 and tell him you got his number from RT on titan talk. see what kind of deal we can get you on a bl and install.

nice truck....:redblob"
 
1 - 20 of 29 Posts