:bump: Just seeing if anyone can give me some advice.....Thanks again for any hep.

 

Hmm...pressure sensor? I'm guessing that would be up by the master cylinder or abs motor to sense pressure on the system. I believe the only thing at the wheels is the sensor ring for wheel speed. Never really looked too closely but see what is plugged in/around the motor and cylinder. Try searching a bit on here or maybe someone with access to a manual or first hand experience will chime in and give you what you are looking for. I'm sure if you can locate it there are some specs it can be tested against for a definite answer on its condition. Or maybe I'm totally wrong, it is almost bed time for me...

 

Ok...you've got this posted in like 4 different places....calm down and let the system work...

Check my reply:
http://www.titantalk.com/forums/titan-wheels-tires-brakes/94880-abs-sensor.html

 

Thanks loufish. I just figured I would post in here as well.

 

Here's the deal....

There's 2 sensors, and most likely the code is from a bad sensor, BUT the code doesn't say which one...

You can do a visual to check the wiring, dis-connect, re-connect to check for corrosion. If you feel it's just a bad sensor, then replace just one, clear the codes and start all over...If the light stays out, you got it on the first try, if not, then switch the sensors front and rear, this will take care of you issue if it's the sensor...Check the price for one...

 

Thanks again, loufish. I will have some time this weekend to mess with it. They reset the code at the dealership when I went to get it looked at and the light hasn't come back on since. Basically, I just want to know if there is any danger of driving on this; will it cause any other damage, etc? The dealership says no, but I don't trust them.

 

Basically, I just want to know if there is any danger of driving on this; will it cause any other damage, etc? The dealership says no, but I don't trust them.

I don't trust dealers either....

There won't be any damaged caused by a sensor failure, but you most likely lose your ABS or ABLS....If part of the ABS sets a code, the system doesn't trust it anymore, so it shuts down the ABS...

 

Just repaired this yesterday,

$225 for the parts,and $160 for the labour.
Lets just hope those lights dont come back on.

 

Hey Guys just got back from the dealership as my Slip light has been on steady for a week , they pulled code C1142 - due to failed rear diff. pressure sensor switch, they quoted 419.00 to fix but I would like to know exactly which sensors are these the ones in the rear hubs or the ones on the master cylinder ? So I can replace myself thanks.

 

These are on the MC.

 

PRESSURE SENSOR | Genuine Nissan | 47240-7S000
Picture and price if your truck is 4wd..

Chris

 

That's the best price I have seen. Is that for both of them?

 

You are correct I miss read it.. that is for the pair..

Chris