Why not post the problem and the solution here, so that others may benefit from the knowledge? This is an open community. We all try to help when we can. That's the best thing about forums. :nerd:

 

Just ran a wire from the red wire running to the right high beam and connected it to into the IPDM. Low beams come on with switch in the parking light position and in the normal low beam position as well, but also they stay on when switched to high beam. Who ever had this truck before me did that wiring and it had just came off and I didn't know neither of that until until I was searching for what could be wrong. When doing the IPDM test the low beam relay still clicks but don't come on? Is that a ground issue or just an issue with the IPDM ? I'd like to repair it fact to factory working order because I'm not sure if it would burn anything up while in the high beam position since both sets of headlights are on

Sent from my SCH-I545 using Tapatalk

 

My money says, since I've owned a T for five years, been active on this forum about that same time, and have never heard of any "low beam issue" your issue is likely related to the prior owner's rewiring job and not anything to do with the Titan.

 

I had the low beam issue as well and had a new IPDM installed to correct it. Nissan Mech said it was common, replacement part had been updated.

 

Actually the low beam issue is quite common. . . . Not sure what forum you've been looking at and I've only been a member of this one for a few months.

Sent from my SCH-I545 using Tapatalk

 

Also have low beam issue hoping my new IDPM will fix it. My high beams recently went too, after alternator failure.

 

I figured out a way to fix my no low beams issue, after a couple weeks of trial and error, new switch, relays, etc, I came to the conclusion that it was the IPDM that had malfunctioned (noticed this happened in quite a few Titans), but the point it I figured out how to make them work correctly without spending $300+ on the new IPDM board. Took half an hour tops. If anyone needs this fix or has questions just message me, I know I had been cratching my head for months trying to find a way to fix this and haven't found any resolution to this issue on any forum besides swapping out for the new upgraded IPDM. View attachment 422921

Sent from my SCH-I545 using Tapatalk

Do u have a picture of how it looks I’m going through this now

 

I figured out a way to fix my no low beams issue, after a couple weeks of trial and error, new switch, relays, etc, I came to the conclusion that it was the IPDM that had malfunctioned (noticed this happened in quite a few Titans), but the point it I figured out how to make them work correctly without spending $300+ on the new IPDM board. Took half an hour tops. If anyone needs this fix or has questions just message me, I know I had been cratching my head for months trying to find a way to fix this and haven't found any resolution to this issue on any forum besides swapping out for the new upgraded IPDM. View attachment 422921

Sent from my SCH-I545 using Tapatalk

I could use some help. I have an Armada and have already replaced the IPDM and the low beams are STILL not working.

 

I figured out a way to fix my no low beams issue, after a couple weeks of trial and error, new switch, relays, etc, I came to the conclusion that it was the IPDM that had malfunctioned (noticed this happened in quite a few Titans), but the point it I figured out how to make them work correctly without spending $300+ on the new IPDM board. Took half an hour tops. If anyone needs this fix or has questions just message me, I know I had been cratching my head for months trying to find a way to fix this and haven't found any resolution to this issue on any forum besides swapping out for the new upgraded IPDM. View attachment 422921

Sent from my SCH-I545 using Tapatalk

Can you send wire

 

Can you send wire diagram to Dragonlance63@Gmail.com

 

I figured out a way to fix my no low beams issue, after a couple weeks of trial and error, new switch, relays, etc, I came to the conclusion that it was the IPDM that had malfunctioned (noticed this happened in quite a few Titans), but the point it I figured out how to make them work correctly without spending $300+ on the new IPDM board. Took half an hour tops. If anyone needs this fix or has questions just message me, I know I had been cratching my head for months trying to find a way to fix this and haven't found any resolution to this issue on any forum besides swapping out for the new upgraded IPDM. View attachment 422921

Sent from my SCH-I545 using Tapatalk

Hello I’m having the same problem on my 2017 Titan can you please send me the fix for low beams not working. Jpqsd@yahoo.com

 

Does the IPDM have to be programmed in a 2008 like the ecu had to be?

 

I figured out a way to fix my no low beams issue, after a couple weeks of trial and error, new switch, relays, etc, I came to the conclusion that it was the IPDM that had malfunctioned (noticed this happened in quite a few Titans), but the point it I figured out how to make them work correctly without spending $300+ on the new IPDM board. Took half an hour tops. If anyone needs this fix or has questions just message me, I know I had been cratching my head for months trying to find a way to fix this and haven't found any resolution to this issue on any forum besides swapping out for the new upgraded IPDM. View attachment 422921

Sent from my SCH-I545 using Tapatalk

I replaced my headlights and passenger pigtail is crap can you send wiring diagram of low beam, side indicator, and blinker on pass side.

 

Devonfarber5@gmail.com
Please. I'd like to know how ya did it.

 

I figured out a way to fix my no low beams issue, after a couple weeks of trial and error, new switch, relays, etc, I came to the conclusion that it was the IPDM that had malfunctioned (noticed this happened in quite a few Titans), but the point it I figured out how to make them work correctly without spending $300+ on the new IPDM board. Took half an hour tops. If anyone needs this fix or has questions just message me, I know I had been cratching my head for months trying to find a way to fix this and haven't found any resolution to this issue on any forum besides swapping out for the new upgraded IPDM. View attachment 422921

 

I have an 18 Titan, shut truck off and passenger headlight stays on . Only way to shut off is to disconnect battery, anybody else have this issue?

 

My 2019 titan has the similar issue. Passenger headlight stays on and blinks rapidly, my led daytime running light are not working. I had a headlight system error warning on my dash a couple days before. Did you find a solution?

 

Part number for the ipdm

 

Also if there are any pictures of how to do this wiring. I can’t pay 1,000 to 1,500 for a light assembly and/or IPDM. This really ruins my love of my current truck. Why manufacturers create these types of insane expenditures for car buyers down the road I have no idea. Just fed up never been so nickel and dimed like my last theee titans. My first two were really reliable and never had an issue

 

PLEASE HELP ME OLD WISE ONE< 2006 Titan